`device-pine64-pinenote-sway.post-upgrade` should check if `sway_hrdl`
is enabled but not installed (like in the case of upgrading from v7-r0
to v8-r0) before setting default session back to `sway`. Else, every
upgrade will set the session back to sway.
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7644>
`device-pine64-pinenote-systemd.post-install` checks if `tinydm-ebc` was
active via `is-active` systemctl command. This does not work in chroot
environment, and exits with exit code 0, thus acting as if `tinydm-ebc`
is active. Since this check is used for v7-r0 to v8-r0 upgrade, it can
be assumed that if output isn't `active`, then the check should not
pass. This commit reworks this by looking for that output rather than a
zero exit code.
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7644>
modem-gnss / qmicli depends on qrtr being up, or it fails on boot and
GPS doesn't work on this device:
sargo systemd[1]: Starting Google Sargo (Pixel 3a) GNSS Modem Setup...
sargo qmicli[1080]: error: node with id 0 not found in QRTR bus
Ideally there would be a path in /dev or sysfs so we could add a
ConditionPathExists= in the unit, but I tried hard to find something and
was unable to. Making modem-gnss depend on ModemManager seems to work
around this issue, since qrtr seems to always (in my testing) be up by
then. IIUC in the future we may not have to run qmicli to enable GPS, so
this patch is a workaround to fix a workaround.
Signed-off-by: Clayton Craft <craftyguy@postmarketos.org>
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7636>
Now that samsung-manta uses EFI boot, its boot partition should be
formatted in FAT32.
Note that the current behaviour does not impair booting nor updating of
kernels and initramfs, but tools like bootctl do not like that.
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7624>
Calls are broken for the Librem 5 with pipewire. Switch to pulseaudio
again until this is resolved by depending on
postmarketosbase-ui-audio-pulseaudio and pulseaudio<9990. The later is
needed as otherwise we get a conflict with pipewire-pulse:
ERROR: unable to select packages:
pipewire-pulse-9991.4.9-r1:
breaks: postmarketos-base-ui-audio-pulseaudio-42-r0[!pipewire-pulse]
satisfies: device-purism-librem5-9-r6[pulseaudio>17]
gnome-settings-daemon-99948.1-r3[pulseaudio]
postmarketos-base-ui-audio-pulseaudio-42-r0[pulseaudio]
That pulseaudio<9990 is needed is not great, but doing it like this
inside the device package is the best way to ensure this doesn't affect
any other devices for now, with the intention to have this change
backported to v25.12 before we announce the release. I've created issue
4187 to discuss how to improve the pulseaudio/pipewire packaging in
general so this isn't necessary in the future.
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7619>
This is device-agnostic, and allows to not depend on a package that
might end up in alpine in the future. In the process, also remove the
unnecessary postmarketos-test dependency in makedepends. That is just
an empty package.
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7553>
Changes are roughly:
- Rebase on-top of 6.12.62
- Add isa1200 driver (from exynos4), and use it on manta (@lat3st)
- Add camera flash for manta (@lat3st)
- Improve manta audio driver to decrease CPU load (@alexmrqt)
- Fix wacom w9000 pen being always active unless inserted (@eisenbahnfan)
- Drop a pm_domain hack, and instead make exynos5 subcmu driver wait
for pm_domain to probe first (@eisenbahnfan)
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7582>
In an effort to have the option to start with a vanilla sway experience,
the sway subpackage is renamed to sway-hrdl to allow for a vanilla sway
config by default, but give the option for hrdl's opiniated
configuration if desired. Non-opiniated eink optimizations will be added to
the now empty sway subpackage as they are developped. A post-install
script was added to move back to vanilla sway.
In favor of using the more automated systemd subpkg. `tinydm-ebc.service` is
removed in favor of an override file for `tinydm.service` packaged in a
device-wide systemd subpackage. A post-install script was added to
disable `tinydm-ebc.service` and enable `tinydm.service` is tinydm is
in-use at time of upgrade.
Enabling systemd units is now handled by postmarketos-base-systemd's
90-base.preset.
Part-of: <https://gitlab.postmarketos.org/postmarketOS/pmaports/-/merge_requests/7515>
Clayton Craft